As requested earlier, here goes with my explanation of how to make an anti-mole windmill thingy.
You will need:
sturdy plastic bottle (coke is ideal)
Drill and suitable drill bit
Old type wire coat hanger
sharp knife
pliers
Firstly, drill a small hole centrally, in the bottle top (ideally just over the thickness of the wire)
[/IMG]
Then repeat process on the bottom -
[/IMG]
Next, cut the bottle sides, to produce 3 even sized propellers. (bend them back and also angle slightly - In the same direction)
[/IMG]
Cut the straight section of the hanger with the pliers ( at the returned end)
[/IMG]
then lay along side your bottle, and allow approximately 6 inches over the length of your bottle,for the support bit, and cut again.
[/IMG]
Gently thread the wire through your bottle ( from the bottle top)
[/IMG]
then once through the bottom, carefully bend (with the pliers) the wire 90 Degrees.
[/IMG]
This has to be done accurately, as the wire must be both 'dead' centre of your bottle, and perfectly straight/horizontal - to allow free movement.
Take your new Molemill 'TM' down to your lottie, and place high as you can in a cane, (Ideal for on top of Munty frame 'TM' )
Here's one I made earlier!!!
Say good bye to Mr Mole!