merry tiller honda replacement

acwid · « **on:** February 13, 2011, 22:07 »

Hi folks need some advice have acquired a gx240 8hp honda off a generator it has a v type tapered shaft the problem is fixing the correct sized pulley to the tapered shaft. I am aware the shaft will need to be cut but it is not keyed so the shaft will need to be drilled and tapped any ideas ,many thanks Chris.

muckshifter · « **Reply #1 on:** February 14, 2011, 22:27 »

Would it be simpler to have the pulley bored to match the taper on the shaft? If you worked out where abouts the pulley needed to sit on the shaft to give correct drive belt alignment the boring of the pulley could take this into account so when fitted it would be pre aligned then the pinch bolt hole in the pulley could be drilled through (taking care not to damage the threads) leaving a dimple in the shaft for the pinch bolt to locate into.

acwid · « **Reply #2 on:** February 15, 2011, 21:48 »

yes you are probably right seams to be the easiest option will look into it

honda FG110 tiller. mantis replacement? Started by Gwiz on Equipment Shed	1 Replies 11622 Views	May 02, 2006, 15:00 by Basil Fawlty
replacement merry tiller engine Started by kenny850 on Equipment Shed	5 Replies 8903 Views	October 07, 2009, 08:46 by kenny850
merry tiller/ honda. Started by Gwiz on Equipment Shed	8 Replies 3406 Views	March 16, 2007, 22:05 by Bigbadfrankie
merry tiller and mantis tiller - compare/contrast? Started by mushroom on Equipment Shed	7 Replies 9376 Views	July 17, 2007, 05:17 by Gwiz

merry tiller honda replacement

acwid

merry tiller honda replacement

muckshifter

Re: merry tiller honda replacement

acwid

Re: merry tiller honda replacement

Similar Topics

honda FG110 tiller. mantis replacement?

replacement merry tiller engine

merry tiller/ honda.

merry tiller and mantis tiller - compare/contrast?