LANDMASTER LION CUB ROTOVATOR

  • 1 Replies
  • 3211 Views
*

aman

  • Newbie
  • *
  • 1
LANDMASTER LION CUB ROTOVATOR
« on: June 23, 2008, 13:36 »
Hello to all. I wonder if someone can help me. I have recently purchased a LANDMASTER LION CUB ROTOVATOR. Iwanted to know some information, and would be grateful for any advice you can give:
1) are the tines on this model constantly engaged?  when I start the rotovator, the tines start rotating straight away.  is this normal, or should I be able to make the engine idle without the tines rotating?
2) I dont seem to have any control over the engine speed: when I start the engine, it goes to maximum speed. There is a control lever on the handle bar, and you can adjust it from "FAST to SLOW" but this makes no difference.  I have traced the cable from the handlebar, and it goes to the base of the engine near the left wheel, then connects to a rod, but this rod does not seem to be connected to anything.  Is this normal.  Any advice on the speed control of this briggs and stratton engine would be extremely welcome.  I can take photos if this helps - thanks

*

Bigbadfrankie

  • Hero Member
  • *****
  • Location: SW Cornwall
  • 1647
LANDMASTER LION CUB ROTOVATOR
« Reply #1 on: June 23, 2008, 17:44 »
Photos would help a lot .
But you do seem to be in need of a few minor repaires
always have a target
and an objective.



xx
Landmaster Lion Cub Rotovator

Started by shaheed on Equipment Shed

1 Replies
1172 Views
Last post September 11, 2015, 12:33
by grendel
xx
Landmaster Lion LS160

Started by Cliff14 on Equipment Shed

0 Replies
777 Views
Last post May 15, 2018, 03:43
by Cliff14
clip
Landmaster LION MANUAL

Started by FionaGeorge on Equipment Shed

6 Replies
589 Views
Last post July 19, 2020, 09:40
by FionaGeorge
xx
Landmaster 88 Rotovator

Started by SimonH on Equipment Shed

27 Replies
20284 Views
Last post April 19, 2015, 10:42
by grendel
 

Page created in 0.099 seconds with 35 queries.

Powered by SMFPacks Social Login Mod
Powered by SMFPacks SEO Pro Mod |