How do I .....

  • 4 Replies
  • 592 Views
*

mrs bouquet

  • Hero Member
  • *****
  • Location: Worthing,West Sussex
  • 4296
How do I .....
« on: August 25, 2019, 10:22 »
Make some holes in the bottom of florists buckets, they are plastic and I haven't got a drill ?   thanks, Mrs Bouquet
Dux Femina Facti

Sometimes my mind wanders, if found please return.

*

Goosegirl

  • Hero Member
  • *****
  • Location: Caton, Lancaster.
  • 7092
Re: How do I .....
« Reply #1 on: August 25, 2019, 11:45 »
Try twisting a sharpened small screwdriver or a scissor blade into the base, or heat them over a cooker and burn the holes.
« Last Edit: August 25, 2019, 11:47 by Goosegirl »
Spring always comes when we sow the seeds of life.

*

Auntiemogs

  • Hero Member
  • *****
  • Location: Isle of Sheppey, Kent
  • 2786
Re: How do I .....
« Reply #2 on: August 25, 2019, 11:47 »
I usually heat up the end of a screwdriver and poke it through.  :)
I would rather live in a world
where my life is surrounded by mystery
than live in a world so small that my mind could comprehend it...✿~ Harry Emerson Fosdick

*

8doubles

  • Hero Member
  • *****
  • Location: Hakin Pembrokeshire
  • 5197
Re: How do I .....
« Reply #3 on: August 25, 2019, 11:53 »
As above a heated large nail , old screwdriver or similar .
I use an electric soldering iron.
A melted hole rarely causes a split to form like a drilled hole does.

*

al78

  • Hero Member
  • *****
  • Location: Horsham, West Sussex
  • 1128
Re: How do I .....
« Reply #4 on: August 26, 2019, 14:21 »
Get a small sharp knife and use it like a hand drill, pointy end down, push down and twist back and forth.


 

Page created in 0.072 seconds with 40 queries.

Powered by SMFPacks Social Login Mod
Powered by SMFPacks SEO Pro Mod |