Howard 352

  • 3 Replies
  • 4653 Views
*

allot100

  • Newbie
  • *
  • 2
Howard 352
« on: August 04, 2013, 17:57 »
Hi,
Am restoring a Howard 352 and need to fit a different engine. The old engine was not the original Briggs and Stratton. Can anyone inform me of the centre height of the engine shaft above the steel block on which the original engine stood?

*

BobE

  • Hero Member
  • *****
  • Location: Near High Wycombe
  • 1590
Re: Howard 352
« Reply #1 on: August 05, 2013, 00:04 »
Well, I put this into Google, (other search engines are available) And found 232,000 hits.  I searched on
"howard 352 rotavator manual"
See if these will help you.


*

allot100

  • Newbie
  • *
  • 2
Re: Howard 352
« Reply #3 on: August 06, 2013, 17:56 »
Thanks for the time spent looking. I've manuals and parts lists for the350. The main difference between the 350 and the 352 is the 'clutch system' and this is the bit I'm having problems with. The system works by an idler pulley tightening the belt. I'm having problems getting the belt to stop so I can get it in gear.


xx
Howard The Gem

Started by walldanzig on Equipment Shed

2 Replies
2143 Views
Last post August 11, 2009, 15:32
by Bigbadfrankie
xx
howard gem

Started by Teabag on Equipment Shed

4 Replies
3308 Views
Last post May 11, 2008, 21:07
by shaun
xx
Howard Gem, or is it?

Started by Dididothat on Equipment Shed

4 Replies
3242 Views
Last post November 27, 2011, 16:21
by R Tallentire
xx
Howard 200

Started by Chris H on Equipment Shed

1 Replies
1745 Views
Last post August 13, 2009, 19:33
by Bigbadfrankie
 

Page created in 0.452 seconds with 31 queries.

Powered by SMFPacks Social Login Mod
Powered by SMFPacks SEO Pro Mod |