Howard 352

  • 3 Replies
  • 4610 Views
*

allot100

  • Newbie
  • *
  • 2
Howard 352
« on: August 04, 2013, 17:57 »
Hi,
Am restoring a Howard 352 and need to fit a different engine. The old engine was not the original Briggs and Stratton. Can anyone inform me of the centre height of the engine shaft above the steel block on which the original engine stood?

*

BobE

  • Hero Member
  • *****
  • Location: Near High Wycombe
  • 1590
Re: Howard 352
« Reply #1 on: August 05, 2013, 00:04 »
Well, I put this into Google, (other search engines are available) And found 232,000 hits.  I searched on
"howard 352 rotavator manual"
See if these will help you.


*

allot100

  • Newbie
  • *
  • 2
Re: Howard 352
« Reply #3 on: August 06, 2013, 17:56 »
Thanks for the time spent looking. I've manuals and parts lists for the350. The main difference between the 350 and the 352 is the 'clutch system' and this is the bit I'm having problems with. The system works by an idler pulley tightening the belt. I'm having problems getting the belt to stop so I can get it in gear.



xx
Howard 400

Started by Dangermouse on Equipment Shed

0 Replies
1418 Views
Last post February 12, 2013, 19:46
by Dangermouse
xx
Howard Gem Help

Started by Dakes55 on Equipment Shed

3 Replies
1741 Views
Last post April 21, 2015, 11:23
by acer
xx
Howard The Gem

Started by walldanzig on Equipment Shed

2 Replies
2113 Views
Last post August 11, 2009, 15:32
by Bigbadfrankie
xx
howard gem

Started by Teabag on Equipment Shed

4 Replies
3290 Views
Last post May 11, 2008, 21:07
by shaun
 

Page created in 0.167 seconds with 39 queries.

Powered by SMFPacks Social Login Mod
Powered by SMFPacks SEO Pro Mod |