landmaster 100

  • 1 Replies
  • 1672 Views
*

derekmc

  • New Member
  • *
  • Location: Cheshire
  • 17
landmaster 100
« on: March 23, 2016, 14:09 »
Have any members had one where did they get spares this is my next project. Also What Briggs Engine size was used?
$_57 (1).JPG
« Last Edit: March 24, 2016, 08:43 by derekmc »
Derek

*

R Tallentire

  • Experienced Member
  • ***
  • Location: Lancaster
  • 240
Re: landmaster 100
« Reply #1 on: March 24, 2016, 22:30 »
I doubt if you will get spares for it. Landmasters were made by Firth Cleveland, the bolt makers, but either taken over or at least marketed by Webb/Atco in the 1980s, by then the 100 was long gone, though the model 88 looks similar. Your engine looks like a 3hp, though the 2.5hp engine shares the same block casting so it is difficult to tell them apart without the fan cowl, which is stamped 80202 for 3hp and 60202 for 2.5hp models.
R Tallentire



xx
landmaster 85

Started by derekmac on Equipment Shed

20 Replies
11594 Views
Last post February 23, 2009, 18:27
by dmac
question
Landmaster 85

Started by daddychubby on Equipment Shed

1 Replies
3135 Views
Last post January 29, 2020, 07:17
by jezza
xx
landmaster 88

Started by HeNrYhOuNd on Equipment Shed

6 Replies
3873 Views
Last post March 21, 2007, 19:43
by leeky
xx
landmaster 85

Started by derekmc on Equipment Shed

0 Replies
1653 Views
Last post June 05, 2011, 21:41
by derekmc
 

Page created in 0.132 seconds with 38 queries.

Powered by SMFPacks Social Login Mod
Powered by SMFPacks SEO Pro Mod |