[grahamk]

Hi all
This is my first post so here goes. Just purchased above saw but it arrived with no instructions regarding changing or altering tension on the blade. I'm more used to the "standard" blade fitting used by other makers but don't want to damage either the saw or my fingers. Sorry to sound stupid but any assistance would be much appreciated.
Thanks for your time
Graham.

[Yorkie]

Welcome to the site 

I'm going to move your post over to the Equipment Shed forum, where it's more likely to be seen by someone who knows the answer 

[riggers24]

Hi Graham

Contact bahco direct, I have in the past for an enquiry I had for a tool I was using at work. They are very helpful, it's www.bahco.com

Regards

Marc