1970 flymo carb question

I have a 1970 Flymo with Tecumseh engine that I am trying to get to work. Unfortunately I removed the  carburetor  to overhaul it without taking picture of linkage. I have the linkage shown in the attached (hopefully) picture but can not figure out how to install it. Does this look familiar to any  one? The only link that is now installed is a spring for the throttle. The engine runs but is rough and dies after about 1 minuet

hello try fitting that linkage where the spring is one end should if my memory serves me right fit in to a governor bar the other pulls the on a piece shaped like a quadrant to regulate the fuel   jezza