Howard 350 Rotavator Cone Clutch

  • 2 Replies
  • 2507 Views
*

topconker

  • Newbie
  • *
  • Location: Salisbury, Wiltshire. UK
  • 6
Howard 350 Rotavator Cone Clutch
« on: April 16, 2020, 12:00 »
Hi, I'm a newby.
I've been given a complete Howard 350 Rotavator that has stood outside for a very long time.
I have removed the motor and am fitting new valves as the gap is way too big, I have installed a new mag and electonic points so think I'm well on the way to getting it running. The problem I have now run up to is have removed the cone clutch and dismantled it to free up the bearings which now run free. On thrying to reassemble it I'm finding the inner cone bottoms out on the pully flange when I tighten down the outer cone, is this right? By looking at the clutch it appears it disengages by pushing the inner cone inwards to seperate it from the outer cone but this is not possible. Any help would be really useful. By the way I have a lot of parts for the motor which is a K141 if anyone is looking for parts.
TC
Kohler 010.JPG

*

jezza

  • Hero Member
  • *****
  • 1602
Re: Howard 350 Rotavator Cone Clutch
« Reply #1 on: April 16, 2020, 20:15 »
Hello Google Howard 350 cone clutch diagrams there's a couple on there jezza

*

topconker

  • Newbie
  • *
  • Location: Salisbury, Wiltshire. UK
  • 6
Re: Howard 350 Rotavator Cone Clutch
« Reply #2 on: April 22, 2020, 12:17 »
Hello Google Howard 350 cone clutch diagrams there's a couple on there jezza

Thanks Jezza, that was useful info. I've now sorted the clutch out by machining some material off of the back edge giving me the clearance I needed to make the clutch work.



xx
howard 350 clutch cone

Started by luke34 on Equipment Shed

2 Replies
3325 Views
Last post October 10, 2015, 20:03
by luke34
xx
howard yeoman repair manual and how to remove clutch

Started by robind7 on Equipment Shed

2 Replies
2851 Views
Last post March 29, 2013, 01:14
by robind7
xx
howard 300 rotavator

Started by david2000 on Equipment Shed

0 Replies
1400 Views
Last post April 27, 2015, 22:09
by david2000
xx
Howard rotavator 400

Started by Fork handle on Equipment Shed

2 Replies
2423 Views
Last post September 08, 2012, 11:51
by Fork handle
 

Page created in 0.173 seconds with 38 queries.

Powered by SMFPacks Social Login Mod
Powered by SMFPacks SEO Pro Mod |