Iseki rotavator

  • 5 Replies
  • 3521 Views
*

rseller3

  • Newbie
  • *
  • Location: Guilsborough - Northamptonshire
  • 1
Iseki rotavator
« on: March 27, 2011, 20:11 »

*

grendel

  • Hero Member
  • *****
  • Location: Canterbury, Kent
  • 2411

*

Gwiz

  • Guest
Re: Iseki rotavator
« Reply #2 on: March 28, 2011, 06:02 »
I think your timing is already set. The first picture shows a woodruf key set into the crankshaft. This,in effect, locks the flywheel in one position and sets the timing.
Just as an aside, in what condition are the points? are they in anyway pitted on the contact surfaces?

*

grendel

  • Hero Member
  • *****
  • Location: Canterbury, Kent
  • 2411
Re: Iseki rotavator
« Reply #3 on: March 28, 2011, 08:53 »
timing is normally achieved by rotating the plate that the points sit on.
Grendel

*

Gwiz

  • Guest
Re: Iseki rotavator
« Reply #4 on: March 28, 2011, 12:37 »
timing is normally achieved by rotating the plate that the points sit on.
Grendel

From the photo provided, it didn't look to me as if the plate moved all that much, if any at all. :)

*

grendel

  • Hero Member
  • *****
  • Location: Canterbury, Kent
  • 2411
Re: Iseki rotavator
« Reply #5 on: March 28, 2011, 17:19 »
your right there doesnt look to be a lot of adjustment, maybe 2 1/2 times the width of the screw heads, and it looks close to one end of travel at the moment, close inspection shows a slight slot. though slackening the points screw might allow them to move slightly too, bu usually thats to adjust the gap.
Grendel



xx
KC4 Iseki Rotavator

Started by morgansbob on Equipment Shed

4 Replies
1827 Views
Last post September 18, 2015, 23:37
by jezza
xx
Iseki KC4

Started by Huzey on Equipment Shed

12 Replies
8798 Views
Last post May 07, 2009, 21:10
by Huzey
xx
iseki kc4

Started by mrmageka on Equipment Shed

2 Replies
1859 Views
Last post August 18, 2011, 06:38
by mower man
xx
Iseki AC-2 rotovator

Started by AlastairR on Equipment Shed

1 Replies
495 Views
Last post July 16, 2021, 16:46
by jezza
 

Page created in 0.08 seconds with 30 queries.

Powered by SMFPacks Social Login Mod
Powered by SMFPacks SEO Pro Mod |