One for the rotovator boys and girls.

Huzey · « **on:** April 02, 2007, 20:33 »

Hey all.
You may have come accross this already, but I just found it doing some research for a project.
clicky
Looks like a lot of interesting bits and pieces.
Hope this is of some interest to you.
Huzey.

muntjac · « **Reply #1 on:** April 02, 2007, 20:42 »

chesters a mate of mine huzey mate . and a member of my other site .he has good old engine spares for most howard s etc and like all rare bits you pay for them , and he does give you genuine spares

Huzey · « **Reply #2 on:** April 02, 2007, 20:50 »

Hi Muntjac
Looking at the list he has got a lot of interesting bits on there. I was looking at the reduction gearbox parts for a T20 fergy, as I am just investigating getting hold of one and getting rid of one of my landrovers. Just an idea at the moment, but could be an interesting experiment. Be quite good popping down the shops on a fergy. Might have trouble keeping the dog in the transport box though!
Interesting link here
All the best
Huzey.

shaun · « **Reply #3 on:** April 02, 2007, 20:54 »

no you get a box fitted to the bonnet for the dog and you put your buttys in the transport box
the fuel can be a problem for the TVO. a mate of mine has one and he mixes his own

Huzey · « **Reply #4 on:** April 02, 2007, 21:27 »

I understand you need a licence to mix and use tvo now. clicky
I had a diesel T20 a few years ago, but sold it on when I left agriculture. Wish I had kept it now.
Not sure I would be able to see round the dog if she sat on the bonnet. I'll either have to get a bigger tractor or smaller dog!
Huzey

shaun · « **Reply #5 on:** April 02, 2007, 22:33 »

he is in some old tractor club i remember him going on about finding his registration documents or something like that,he uses kero like on that link

does a great job if you have the room

http://www.chat.allotment-garden.org/album_pic.php?pic_id=81

Huzey · « **Reply #6 on:** April 04, 2007, 15:17 »

Looks fantastic. I am keeping my eyes open at the moment, but the old funds have taken a battering lately, so might have to wait until next year, unless one comes up on freecycle of course???

shaun · « **Reply #7 on:** April 04, 2007, 21:21 »

your looking around a grand for a runner then you have the attachments to get on top.
one guy on our site has a small kuboto with a rotavator attachment there ok ,dont go as deep though but deep enough

Huzey · « **Reply #8 on:** April 04, 2007, 21:33 »

The prices have gone up alarmingly, as apparently, classic tractors are the next big thing. I bought a registered running international 454 a few years ago for 600 quid, a 3 tonne tipping trailer for 25 quid and a 6' rotovator for 150 quid, all in good nick, (apart from the trailer). I think you'd be looking at 1500 for the tractor now and 4-500 for the rotovator.
I think I shall give it a few months and see if they go out of fashion again.
Huzey

Bigbadfrankie · « **Reply #9 on:** April 06, 2007, 22:58 »

I have a fergy 35, a super dexter and a international.

shaun · « **Reply #10 on:** April 06, 2007, 23:20 »

have you got a bit of a museum going on there in darkest cornwall mate

Huzey · « **Reply #11 on:** April 07, 2007, 10:47 »

Quote from: "Bigbadfrankie"

I have a fergy 35, a super dexter and a international.

Nice. Is it a 3 or 4 cylinder 35? Assuming it is a diesel, that is.
Think I would plump for the super dexta myself.
Regards Huzey.

Bigbadfrankie · « **Reply #12 on:** April 07, 2007, 19:20 »

it a 4 and has to be towed for miles to get it to start :roll:

shaun · « **Reply #13 on:** April 07, 2007, 19:42 »

i know what you meen about starting them
,so is it a diesel then ?

Huzey · « **Reply #14 on:** April 08, 2007, 09:40 »

I reckon it must be.
picky clicky
Photo of my old international.
Regards Huzey.

Hello boys... Started by Sadgit on Equipment Shed	16 Replies 3900 Views	October 19, 2007, 10:40 by muntjac
what rotovator Started by dave123 on Equipment Shed	9 Replies 6574 Views	May 20, 2009, 23:38 by dave123
rotovator help. Started by arthur cooke on Equipment Shed	8 Replies 4252 Views	February 13, 2008, 11:56 by arthur cooke
rotovator Started by bluedog on Equipment Shed	0 Replies 1606 Views	September 04, 2012, 22:38 by bluedog