[Jamie R]

Hi there,

I'm looking to tap your knowledge of the Howard 350.  I have recently bought one and the engine runs fine, but the rotors 'jump' out of gear once you have engaged them.

I have taken off the top of the selector rod and can see that the teeth in the selector cog are a bit worn.  (are they meant to have an angle on one edge for engaging or should they be square?)

But looking at the selector rod - it is as if the rod is the wrong shape, as when it is in the engaged position it is hard up against the housing.  It feels like if the rod could move across a few more mils more then the rotors would engage correctly.

Has anyone experienced this and what could I do fix it.  Is it possible to get a new selector?  If so I cannot seem to find a source of parts (except ebay)

Advice / comments welcome.

JR

[dorimower]

I know nothing about Howards.....but I do know that they get very regularly discussed on the VHGMC forum.. http://www.tractorbox.co.uk/forum/default.asp 

Clive.

[Bigbadfrankie]

are yOu aloud to mention VHGMC  on here?

[dorimower]

I suspect not.. ....but I got away with it last time...

Clive.